How to Pattern Unlock the Celkon Mobile A9+, Pattern Lock solution Celkon A9+ 100% Solved by using Volcano Box and the Volcano Tool V2.0.6. So if your are facing problem to unlock the pattern lock on your mobile Celkon A9+ then follow the procedure given below.
How to Hard Reset Celkon A9+ With Volcano Box
- Download Volcano Tool V2.0.6
- Go to SPD Tab Select Built-in Boot_14(6820/8810)
- Click on Format
- Connect the Jig Connector P-05B to the Phone with the Main Cable
- Remove the Phone Battery and Connect the Box Power Cable to the Phone
- Click on Run Then Click Yes
- Then Press the Volume Down (-) Key
- Note: Boot Key for Celkon A9+ = Volume Down Key (Volume -)
Celkon A9+ Connect the Power Cable (Volcano Box Power) ( Left Pin + and Middle Pin - ) |
Celkon A9+ Format/ Hard Reset/ Pattern Lock Solved on 04/12/2013 Tested on 4th December, 2013
Celkon A9+ Pattern Lock Removed by Volcano Box ( Celkon Hard Reset) |
****************************************************
Volcano Updated: 2013-04-28
Connecting...
Connection successful,connected state!
Version: V3.8
SN:524-422-108
Port:COM6
After format or Flash you have to press & hold power button for at least 1.30 mins.
Available Ports:COM1 COM4 COM6
Detection initiated...
Vcc: null
Gnd: 5
Analyzing D+ and D-...
D+ = 3, D- = 2
Analyzing USB device, please wait...
Find USB device:SCI USB2Serial (COM7), (VID_1782&PID_4D00)
Internal version: SPRD3
Boot downloaded.
Start boot please wait a moment....
Spreadtrum Boot Block version 1.1
Boot downloaded.
Flash ID: 009800BC
FLASH LEN:0x20000000
>>Set to Factory successfully.
Connecting...
Connection successful,connected state!
Version: V3.8
SN:524-422-108
Port:COM6
After format or Flash you have to press & hold power button for at least 1.30 mins.
Available Ports:COM1 COM4 COM6
Detection initiated...
Vcc: null
Gnd: 5
Analyzing D+ and D-...
D+ = 3, D- = 2
Analyzing USB device, please wait...
Find USB device:SCI USB2Serial (COM7), (VID_1782&PID_4D00)
Internal version: SPRD3
Boot downloaded.
Start boot please wait a moment....
Spreadtrum Boot Block version 1.1
Boot downloaded.
Flash ID: 009800BC
FLASH LEN:0x20000000
>>Set to Factory successfully.
****************************************************
Thanks bro,,,, its works for me,,,,,, Thanks alot :)
ReplyDeleteits telling pinout not found
ReplyDeleteHi Waseem
DeleteRead carefully the tutorial and follow all the steps then try, it must work, if not then you may have problem with the Charging Connector.